Laser cleaning is a new cleaning method, and handheld laser cleaning is more widely used. Hand-held laser cleaning head is beautiful in appearance, small and light
Convenient, wide range of use, simple operation, greatly improving cleaning efficiency and quality. Handheld laser cleaning solves the problem of existing corners
It is easy to clean, rust needs to be polished, and the polishing is not beautiful. It is the first choice for most metal cleaning.
So more and more customers will buy the laser cleaning machine , and here is showed the laser cleaning head operate step for you when installed the machines .
Operation steps
1. Connect the circuit between the laser, the controller and the galvanometer driver, connect the power cord, and refer to the user manual for the wiring method.
Electronic control part>.
2. After getting the laser cleaning head, connect the optical fiber connector first, and then connect the air pipe, water pipe and switch circuit.
(The detailed installation method of each connector is provided later)
3. Turn on the power of the controller, wait for the screen of the laser controller to start up, then turn on the laser switch and the water cooler switch.
4. Set the relevant values on the controller screen (refer to <User Manual Electronic Control Section> to set various parameters).
5. Put on goggles, hold the cleaning head in your hand, and turn the cleaning head toward the metal rust, and observe whether the cleaning head has red light. like
If no red light appears, check whether the laser emits light normally.
*Note: Just observe the red light on the side of the cleaning head, and it is strictly forbidden to look directly at the laser rays.
6. Place the workpiece well, adjust the angle of the cleaning head so that the red light shines on the rust that needs to be cleaned, and observe the focus of the red light indicator and the laser beam.
The red light of the light is indicated on a horizontal line, then press and hold the switch on the cleaning head for 2 seconds (can be set) until the light indicator is on,
Release the switch and press it again to emit light for cleaning, as shown in Figure 4-1, 4-2.
*Note: If you can't see the red light indication of the laser at all, do not use the laser.