Fiber laser cutting machine usage tips and precautions

1. Tips for using fiber laser cutting machine

1) The bifocal laser cutting head is a vulnerable item on the laser cutting machine. Long-term use may cause damage to the laser cutting head.

2) Check the straightness of the fiber laser cutting machine track and the verticality of the machine every six months, and perform maintenance and debugging in time if any abnormalities are found. If you don't do this, the cutting effect may not be very good, the error will increase, and the cutting quality will be affected. This is a top priority and must be done.

3) Use a vacuum cleaner to suck out the dust and dirt in the machine once a week. All electrical cabinets should be closed tightly to prevent dust.

4) Check the fiber laser cutting machine steel belt frequently and make sure it is tightened. Otherwise, if something goes wrong during operation, people may be injured, or even fatal. The steel belt may seem like a small thing, but the problem is still serious.

5) Each guide rail of the fiber laser cutting machine should be cleaned frequently to remove dust and other debris to ensure that the equipment is normal. The racks should be wiped frequently and lubricated to ensure lubrication and no debris. The guide rails must be cleaned and lubricated frequently, and the motor must also be cleaned and lubricated frequently. The machine will be able to move better and cut more accurately during travel, and the quality of the cut products will be improved. . 

2. Precautions for fiber laser cutting machine

Things to note when operating a laser cutting machine include the following:

1). Follow general cutting machine safety operating procedures. Strictly follow the laser startup procedures to start the laser, adjust the light, and test the machine.

2). The operator must be trained, familiar with the cutting software, equipment structure and performance, and master the relevant knowledge of the operating system.

3). Wear labor protection equipment as required, and wear protective glasses that comply with regulations when near the laser beam.

4). Do not process a material before knowing whether it can be irradiated or cut by laser to avoid the potential danger of smoke and vapor.

5). When the equipment is running, the operator is not allowed to leave the post without authorization or leave it to someone else to take care of it. If it is really necessary to leave, the operator should stop the machine or cut off the power switch.

6). When an abnormality is discovered during processing, the machine should be stopped immediately and the fault should be eliminated or reported to the supervisor in a timely manner.

7). Keep the fire extinguisher within easy reach; turn off the laser or shutter when not processing; do not place paper, cloth or other flammable materials near the unprotected laser beam.